I recently started a build based on the Intel DH87RL. When all memory slots are populated with 8GB sticks (32GB total) the machine fails to POST. In fact, the machine will begin its start up sequence, run for about 10 seconds, then reboot. After roughly 5 cycles, the machine will finally throw POST error beeps (3 beeps, pause, 3 beeps, pause, 3 beeps, pause) and then finally restart the entire process again.
Interestingly, if I remove _any_ of the 4 sticks of RAM, the machine will boot fine. The board has been flashed with the latest BIOS and the BIOS has been reset to factory defaults. Memory tested includes Crucial Ballistix Tactical BLT2KIT8G3D1608DT1TX0 16GB 240-Pin DIMM DDR3 1600 and Crucial Ballistix Tactical Low Profile 32GB Kit (8GBx4) DDR3 1600 1.35V UDIMM 240-Pin BLT4C8G3D1608ET3LX0.
Any solutions?
-Pete
