We bought PAN1322 EVM & we are evaluating the module .
It works properly with our android tab which has Bluetooth version 2.0 .
While using it with android tab which has Bluetooth version 4.0
I am getting sniff mode confirmation & sniff sub rating event continuously .
We need high data rate .
So we don't want sniff mode .
Is there any way to switch off this sniff mode confirmation & sniff sub rating reply.
I am getting this while during data transfer as well .
I have gone through at command set
The command to switch off this sniff mode is
AT+JSNF=0002,0002,0000,000F,0
So the last byte is for switching off the sniff mode (0-on 1-off).
I have tried the above command , sometimes I am getting err – 2 . sometimes I am not getting any reply .
But even after sending this command I am getting those two response .
We doesn`t have any issue in ignoring those two response from Host controller side . But since it is going into sniff mode .
We want high data throughput . we don’t want data latency to be high .